IT. Expert System.

RFC (proposed standard status)

The audio/mpeg Media Type. M. Nilsson. November 2000. RFC3003. (Format: TXT=8381 bytes) (Status: PROPOSED STANDARD) (DOI: 10.17487 / RFC3003)


 Network Working Group                                         M. Nilsson
Request for Comments: 3003                                 November 2000
Category: Standards Track
                       The audio/mpeg Media Type
Status of this Memo
   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.
Copyright Notice
   Copyright (C) The Internet Society (2000).  All Rights Reserved.
Abstract
   The audio layers of the MPEG-1 and MPEG-2 standards are in frequent
   use on the internet, but there is no uniform Multipurpose Internet
   Mail Extension (MIME) type for these files.  The intention of this
   document is to define the media type audio/mpeg to refer to this kind
   of contents.
   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in RFC 2119 [RFC2119].
1.  MPEG audio
   The audio compression defined as layer I, layer II and layer III in
   the MPEG-1 [MPEG-1] and MPEG-2 [MPEG-2] standards is a popular method
   of compressing audio with a low quality loss.  The compressed audio
   is split into several small data frames, each containing a frame
   header and compressed audio data.
   The mime type audio/mpeg defines a elementary byte stream containing
   MPEG frames according to [MPEG-1] and [MPEG-2], possibly interspersed
   with non MPEG data.  Non MPEG data is data without MPEG
   synchronization or in other ways not possible to decompress without
   error.
   Typically MPEG audio meta data is concatenated with the MPEG stream,
   e.g., the meta data format ID3 puts a 128 byte data block in the end
   of the stream while ID3v2 [ID3V2] prepends a data block of variable
Nilsson                     Standards Track                     [Page 1]

RFC 3003               The audio/mpeg Media Type           November 2000
   size to the stream.
   NOTE: MPEG audio was not designed as a file format but as a format
   for transmitting audio streams.  As such, it does not have any well
   defined way of including meta data along with audio information.
   Some products embed meta data using zero amplitude frames or
   disguised as transmission errors.  Others embed the MPEG data in WAV
   format.
   NOTE: The audio/MPS mime type is in use in addition to the
   audio/mpeg.  The MPA [RFC 1890] sub-type refers to MPEG audio when it
   is segmented and send as a Realtime Transport Protocol (RTP) payload.
2.  Registration Information
   To: ietf-types@iana.org Subject: Registration of MIME media type
   audio/mpeg
   MIME media type name: audio
   MIME subtype name: mpeg
   Required parameters: none
   Optional parameters: none
   Encoding considerations:
       For use over internet it is assumed that lower layers take care
       of transmission errors, so audio/mpeg data MAY include MPEG
       frames generated without the optional cyclic redundancy checks
       (CRC) for improved audio quality.
       The MPEG audio data is binary data, and must be encoded for
       non-binary transport; the Base64 encoding is suitable for Email.
       Note that the MPEG audio data does not compress easily using
       lossless compression.
   Security considerations:
        MPEG is a tagged data format, and some tags are available for
        private use.  As such, arbitrary material could potentially
        be transferred in the MPEG stream, including executable content.
        Tagged data containing executable content SHOULD never be sent
        and MUST not be executed if it is received.
Nilsson                     Standards Track                     [Page 2]

RFC 3003               The audio/mpeg Media Type           November 2000
                                NOTE
            The requirement that such content not be executed on receipt
            is especially important since situations exist where content
            will be generated independently and therefore could contain
            executable content that the sender is unaware of.
        Audio/mpeg objects are not signed or encrypted internally.
        External security mechanisms must be employed to ensure content
        confidentiality
   Interoperability considerations:
       MPEG audio has proven to be widely interoperable across computer
       platforms.
   Published specification: see [MPEG-1] and [MPEG-2]
   Applications which use this media type:
       MPEG audio is device-, platform- and vendor-neutral and is
       supported by a wide range of encoders and decoders (players).
   Additional information:
       Magic number(s): none
       File extension(s): .mp1, .mp2, .mp3
       Macintosh File Type Code(s): MPEG
       Object Identifier(s) or OID(s): none
   Person & email address to contact for further information:
       The author of this document.
   Intended usage: COMMON
   Author/Change controller: Martin Nilsson (see section 5)
   3.  Security Considerations
   Security considerations are discussed in the security considerations
   clause of the MIME registration in section 2.
Nilsson                     Standards Track                     [Page 3]

RFC 3003               The audio/mpeg Media Type           November 2000
4.  References
   [ID3v2]
     Martin Nilsson, "ID3 tag version 2.3.0".
     <url:http://www.id3.org/id3v2.3.0.txt>
   [MPEG-1]
     ISO/IEC 11172-3:1993.
     Coding of moving pictures and associated audio for digital storage
     media at up to about 1,5 Mbit/s, Part 3: Audio.
     Technical committee / subcommittee: JTC 1 / SC 29
   [MPEG-2]
     ISO/IEC 13818-3:1995
     Generic coding of moving pictures and associated audio information,
     Part 3: Audio.
     Technical committee / subcommittee: JTC 1 / SC 29
     and
     ISO/IEC DIS 13818-3
     Generic coding of moving pictures and associated audio information,
     Part 3: Audio (Revision of ISO/IEC 13818-3:1995)
   [RFC2119]
     Bradner, S., "Key words for use in RFCs to Indicate Requirement
     Levels", BCP 14, RFC 2119, March 1997.
5.  Author's Address
   Martin Nilsson
   Rydsvagen 246 C. 30
   S-584 34 Linkoping
   Sweden
   EMail: nilsson@id3.org
Nilsson                     Standards Track                     [Page 4]

RFC 3003               The audio/mpeg Media Type           November 2000
6.  Full Copyright Statement
   Copyright (C) The Internet Society (2000).  All Rights Reserved.
   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.
   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.
   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
   Funding for the RFC Editor function is currently provided by the
   Internet Society.
Nilsson                     Standards Track                     [Page 5] 


Content

Android Reference

Java basics

Java Enterprise Edition (EE)

Java Standard Edition (SE)

SQL

HTML

PHP

CSS

Java Script

MYSQL

JQUERY

VBS

REGEX

C

C++

C#

Design patterns

RFC (standard status)

RFC (proposed standard status)

RFC (draft standard status)

RFC (informational status)

RFC (experimental status)

RFC (best current practice status)

RFC (historic status)

RFC (unknown status)

IT dictionary

License.
All information of this service is derived from the free sources and is provided solely in the form of quotations. This service provides information and interfaces solely for the familiarization (not ownership) and under the "as is" condition.
Copyright 2016 © ELTASK.COM. All rights reserved.
Site is optimized for mobile devices.
Downloads: 7744 / . Delta: 0.03052 с